Honeywell dial set chronotherm manualidades

#HONEYWELL DIAL SET CHRONOTHERM MANUALIDADES MANUAL#

вќ‘ Make sure that the SYSTEM switch on the thermostat is set to Heat or Cool (T8775C only). Allow compressor to remain off for five minutes before restarting. Honeywell T8775A,C Troubleshooting GuideД¬an cause permanent damage to compressor orДo not operate cooling when outside temperature is below 50вЏ (10вЊ). вќ‘ To raise the temperature setting, turn the dial clockwise. вќ‘ To lower the temperature setting, turn the dial counterclockwise. вќ‘ A indicator points to Room when the room temperature is displayed. Temperature setting is not made within five seconds, the mode will switch to the room temperature display. A indicator points to Set when the temperature setting is displayed. вќ‘ Turn the dial one click to display the current temperature setting. NOTE: Your temperature setting can be set anywhere from 40вЏ to 90вЏ (4вЊ to 32вЊ) in heating and 45вЏ to 99вЏ (7вЊ to 37вЊ) in cooling (T8775C only). вќ‘ The backlight can be turned on by turning the dial, or by pushing the backlight button as shown in Fig. NOTE: Batteries are not required because the temperature setting is held permanently in memory. The fan only runs with the heating and cooling system. вќ‘ Cool: The thermostat controls your cooling system. вќ‘ Off: Both heating and cooling systems are off. вќ‘ Heat: The thermostat controls your heating system. 1).Дo not operate the T8775C in cooling mode when the outdoor temperature is below 50вЏ (10вЊ), or damage to compressor could result.

вќ‘ System and Fan settings are controlled by using SYSTEM and FAN switches located on the top of the thermostat (see Fig.

#HONEYWELL DIAL SET CHRONOTHERM MANUALIDADES MANUAL#

About Honeywell T8775A,C Manual Setting SYSTEM and FAN Switches (T8775C only)

Honeywell dial set chronotherm manualidades